Unfortunately it is true, the Freelander one.eight petrol is prone to head gasket failure. In reality, this is a typical issue for all cars that use the Rover K series engine. Why?
Place a little amount of silicone lubricant on both the motor shaft and in the mechanical seal recess. This lubrication assists the seal assembly to slide into place a little simpler. Make sure that you set up both halves of the seal assembly in the same method as the original. The white ceramic part of the seal with the black rubber cup, goes into the seal plate. The glass finish Should be facing you.
However this does not solution the question as to why the head Gasket fails. The motor block and cylinder head are aluminum. Oil and water (with coolant) movement via channels right here and if they lose their viscosity then it causes the engine to run at a greater temperature than normal, which puts pressure on the head Flange Insulation Gasket and can trigger it to blow.
Finally, use a thoroughly clean rag with only warm drinking water to rinse the area out and allow it totally dry before you near the doorway, you may need to use a chair or other item to hold the door open up.
While it is possible to function Spiral Wound Gasket around the belt, it is usually simpler and less frustrating to loosen the belt and transfer it out of the way. It is particularly hard to get the base bolt restarted into the gap properly with the belt in location.
After removing the Double Glazed Unit it is recommended to take it to your nearby Glass Service provider for them measure it and verify for any special coatings that the glass may have on it. If the Double Glazed Device was sitting on plastic packers when you eliminated it, consider them with you and inquire the Glass Service provider if they are the correct packers for the job, if not, get the right packers. This is extremely essential as the trigger of most Double Glazed Device Breakdowns (misty / condensation in between glass) is that they have not been equipped on the right packers. If your window is glazed on security tape you will require to buy some new double sided safety tape.
If you continue to generate your Freelander you run the risk of cracking the head cylinder or harmful the cylinder block liners – which will mean that on leading of the price of replacing the head gasket you will also have to buy a new cylinder head!